Ceia PD240CH Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wykrywacz metali Ceia PD240CH. Ceia PD240CH 20 stron.

Drukuj stronę

Maintenance

Signal or symptom

Both intermittent RED

alarm and audio signals

during use.

Operational verification

failure.

Battery charging process

does not start.

Intermittent RED alarm

during battery charging

process

3.3

Procedure for replacing batteries

Remove the locking screw from the cap of the battery compartment, using a TORX 10

key. Replace the batteries, respecting their polarity, as illustrated in the figure below.

Replace the battery compartment cap and secure it tightening the locking screw.

Probable cause

Fault

Test procedure carried

out incorrectly.

Wrong procedure or

dirty electric contacts.

Dirty electric contacts

Damaged battery,

absent or wrongly

inserted.

FI100K0025v1100 UK - - PD240CH

Action

Discontinue equipment use and

contact service department.

Power cycle the detector, wait for

"ready for use" signal and repeat the

procedure correctly.

In case of repeated failure,

discontinue equipment use and

contact service department.

Extract the detector from HHDS

module and verify that it is off. Verify

that the HHDS is connected to the

AC power supply. Place again the

detector inside the HHDS module.

In case of repeated failure:

Verify that the AC power supply

is available

Check that the contacts of the

detector and the spring pins of

the HHDS are clean and

working properly

replace HHDS module

In case of repeated failure,

discontinue equipment use and

contact service department.

Check that the contacts of the

detector and the spring pins of the

HHDS are clean and working

properly.

Check the batteries condition and

replace them if necessary (see

procedure below).