75F Pressure Controller Instrukcja instalacji i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Akcesoria 75F Pressure Controller. 75F Pressure Controller 7 stron. Pressure sensor package
Drukuj stronęTurn power off. 18AWG T-stat wire is recommended. Follow the
wiring diagram to wire the Smart Node and the A/DP2 Pressure
Sensor.
Powering the controller. Use 18/2AWG to run power from the 24VAC
transformer to the 75F Smart Node as shown below.
Wiring the A/DP2. Use 18/3AWG to run power from the 75F controller
to the pressure sensor as shown in Fig.3. The power for the A/DP2 is
internally connected so that the controller will power the A/DP2
pressure differential sensor.
Fig.4
Low Pressure Port connects to outside and High Pressure
Port connects to inside.
polyethylene tubing. Push one end over the brass fitting on the A/DP2
Using a length of ¼" O.D., 0.170"ID
Pickup
Exterior
Pickup
Port
Interior
www.75f.io
888.590.8995 x2
Port