Hi-Velocity HE PS Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Oczyszczacz powietrza Hi-Velocity HE PS. Hi-Velocity HE PS 8 stron.

Drukuj stronę

HE PS

Air Flow

Fig. 3 Vertical Installation

When installing the HE PS to a Hi-Velocity 50 or

70 fan coil, a transition should be made (Fig. 4) or simply

block air flow with a piece of sheet metal (Fig. 5).

Top View

Transition

RPM-E-70

HE/HV/HE-Z-70

Fan Coil

Fig. 4 Transition

Hi-Velocity Fancoil

RPM-E

Return Air Base

HE PS

Create transition from

18 ga. sheet metal

HE/HV/HE-Z-70

Fig. 5 Block Air Flow

Tape all seams between the air handler and the

outlet side of the HE PS so there can be no air bypassing

the system.

Attach the air handler to the outlet side of the

HE PS and fasten with #10 x 3/8 self-drilling sheet

metal screws.

NOTE: Only 1/2 inch of clearance has been provided

between the outer and inner case.

Slide the components into the outer case

and tighten locking knobs finger tight. Make sure the

inner module will freely slide in and out of the outside

enclosure.

Plug in the power cord to any 120vac outlet

and check both sight ports to make sure both lamps

are

illuminated. Ultraviolet lamps must remain on at

all times regardless of thermostat or AirCycler settings.

Check the service panel (Fig. 11). The LED

lights should be flashing in sequence for a 15 second

period of time and then return to green. The filter lamp

should be flashing green and the UV lamp light should

be a steady green.

Set the thermostat or the AirCycler to operate

the fan unit for at least 25 minutes every hour. If air

10.

quality problems persist after one week, increase the

fan unit operating time by (5) minute intervals.

(3)

Top View

HE PS

RPM-E-70

Block air flow with

18 ga. sheet metal

Fan Coil