DYNACO PAT5PWR Instrukcja montażu - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wzmacniacz DYNACO PAT5PWR. DYNACO PAT5PWR 18 stron. Replacement power supply rev e hardware

Important Safety Notes

By purchasing, using, or assembling this kit, you have agreed to hold Akitika LLC

harmless for any injuries you may receive in its assembly and/or use. To prevent injuries:

 Wear safety glasses when soldering or clipping wires to prevent eye injuries.

 Always unplug the power before working on the amplifier.

 Large capacitors hold lots of energy for a long time. Before you put your hands

into the amplifier:

o Pull the AC plug!

o Wait 2 full minutes for the capacitors to discharge!

 Remove jewelry and rings from your hands and wrists, or anything that might

dangle into the amplifier.

 If working one the equipment with the power on, keep one hand in your pocket,

especially if you're near the power supply or power supply wires. This can

prevent serious shocks.

 Build with a buddy nearby. If you've ignored all the previous advice, they can

dial 911 or get you to the hospital.

 Read and understand the safety manuals of all the tools you use.

We reserve the right to make design/or component changes at any time without prior

The kit must be assembled with 60/40 Rosin Core solder. The recommended diameter is

0.032 inches. Among many such sources of solder, I have used Radio Shack part number

64-009. It contains 8 oz. of solder, which is much more than you'll need to assemble this

kit.

With the exception of fuses, Akitika LLC will replace for free any parts of a correctly

assembled product that fails within one year of the date of purchase when the equipment

has been used in home stereo applications. It is the responsibility of the kit builder to

install the replacement part(s). This warranty applies to the original purchaser only. It

does not apply to units that have been physically or electrically abused, modified without

prior factory authorization, or assembled with other than 60/40 Rosin Core solder.

Akitika LLC's liability shall in no event exceed the cost paid to Akitika LLC for the kit.

notification.

Page 4 of 18