ADEMCO LYNX Instrukcja obsługi systemu - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi systemu dla System bezpieczeństwa ADEMCO LYNX. ADEMCO LYNX 14 stron.
Również dla ADEMCO LYNX: Podręcznik użytkownika (17 strony), Skrócona instrukcja obsługi (8 strony)
Drukuj stronę
Ademco Lynx System Manual
system will announce "END MESSAGE" and "REC MESSAGE" will not be displayed. If the
message center is full all old messages must be deleted before new messages can be recorded.
See Deleting Messages section.
Message Playback
The lighted word MESSAGE indicates that a new message is in memory. After playing the message, the
MESSAGE display turns off.
To play a message, press [FUNCTION] + [PLAY].
All recorded messages will be announced sequentially. A short beep will sound between messages.
To skip a message, press [*].
NOTE: If a wireless keypad has been installed and is programmed for quick arming, it cannot
be used to activate message playback or adjust the volume. In this case, you must use the
master keypad to perform these functions.
Deleting Messages
To delete all messages:
1. Press [FUNCTION] + [PLAY].
2. While the messages are being announced, press [FUNCTION] + [DELETE].
3. A double beep will sound confirming that the messages have been deleted.
Adjusting the Volume
The volume level of message playback, system announcements, and status beeps can be changed. You
can also mute system announcements if desired.
To adjust message playback/system announcement volume:
1. Press [FUNCTION] + [VOLUME] + [3] to increase or [6] to decrease volume level.
2. Repeat the key sequence until the desired volume level is achieved.
To mute system announcements:
1. Press [FUNCTION] + [VOLUME] + [OFF].
2. The volume level will be restored to the level that was selected prior to muting the sound.
Paging Features
Automatic Paging
http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]