Great Plains Industries FM-300HR Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Great Plains Industries FM-300HR. Great Plains Industries FM-300HR 16 stron. Electronic disc meter
Drukuj stronę
Your Actions
5. (continued)
6. Once the flow has stopped, briefly press and
release both buttons. At this point the compu-
ter display will change to "0000.00" with the
left-hand digit blinking.
7. Enter the volume (amount) of fluid that you dis-
pensed (for example, if your 10-gallon container
is full, enter "10.0" for gallons or "37.85" for
litres). To enter numbers use the CALIBRATE
button to change the value of the digit that is
blinking and use the DISPLAY button to shift
the "blink" to the next digit.
8. Once the correct number has been entered,
briefly press and release both buttons. The dis-
play will change to a blinking "run 02" message. ready to end calibration
9. To enter another calibration point, go back
and repeat Steps 3 through 8.
8
Notes
more fluid or repeatedly
starting and stopping the
flow - these actions will result
in less accurate calibrations.
When the display shows
"0000.00" the computer has
stopped "watching" for fluid
flow and is now waiting for
you to enter some numbers.
You have installed a new
cal-curve point. You are
(Step 10) or enter another
new calibration point (Step 9).
It is possible to set up to 15
cal-curve points, and the
"run ##" message will incre-
ment each time you repeat
the calibration process
(run 01, run 02, run 03, etc.,
up to run 15).