Agrilight AGRIBOX pro Skrócona instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Systemy kontroli Agrilight AGRIBOX pro. Agrilight AGRIBOX pro 20 stron.

Divide the fixtures into groups

You have created groups and the fixtures have been found. You can now assign the fixtures to

the groups. This has to be done individually for each fixture, so this may take some time. Have

you divided all the fixtures into groups? Then you are ready to set lighting programs.

Press

and go to Settings > Assign.

Set lighting programs

A lighting program allows you to switch the fixtures on and off within a period of 24 hours at the

times desired by you. A total of 10 lighting programs can be set. 8 times can be set per lighting

program.

and go to Program

Press

Example:

From 6:30 a.m. until 10:30 p.m. the group of fixtures belonging the program 1 must be

switched on 100%. The group of fixtures must then switch off. Enter the times as follows:

Time 1: The group of fixtures switches on at 6.00 a.m.

Time 2: From 6:00 a.m. until 6:30 a.m. the light power is gradually increased up to 100%.

Time 3: From 6:30 a.m. until 10:30 p.m. the group of fixtures remains switched on at 100%.

Time 4: From 22:30 p.m. until 23:00 p.m. the light power is gradually decreased down to 0%.

Times 5 to 8 can be entered if you wish for the group of fixtures to be switched on and off at

several times.

The first and last time must always be 0%. If this is not the case, the fixture will

remain switched on.

Linking lighting programs to groups

Have you created groups, assigned fixtures to groups and set lighting programs? You can now

link the lighting programs to groups in a few simple steps.

Set control light

The control light is the red LED lighting and is the minimum lighting for being able to monitor

the buildings at night without disturbing the animals in their day and night rhythm.

One program can be set for the control light. This program then applies to all the groups.