GREAT PLANES COMBAT MUSTANG Combat P-51 ARF Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES COMBAT MUSTANG Combat P-51 ARF. GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 20 stron.

Drukuj stronę

GREAT PLANES COMBAT MUSTANG Combat P-51 ARF Instrukcja obsługi

PREPARATIONS

1. If you have not done so already, remove the major

parts of the kit from the box and inspect for damage. If any

parts are damaged or missing, contact Product Support at

the address or telephone number listed in the "Kit

Contents" section on page 5.

2. Remove the tape and separate the ailerons from the

wing and the elevators from the stab. Use a covering iron

with a covering sock on high heat to tighten the covering if

necessary. Apply pressure over sheeted areas to

thoroughly bond the covering to the wood.

BUILD THE WING

Install the Ailerons

1. Test fit the ailerons to the wing with the hinges,

making sure the aileron torque rod fits into the hole in the

aileron. Once you are satisfied with the fit, remove the

aileron from the wing. Insert the hinges into the slots in the

aileron. If the hinges did not remain centered, stick a pin

through the middle of the hinge to hold it in position.

2. Apply a small amount of 6-minute epoxy into the

hole in the aileron for the aileron torque rod. Working quickly,

install the aileron to the wing. Use rubbing alcohol to clean

any excess epoxy from the aileron and wing.

3. Remove any pins you may have inserted into the

hinges. Adjust the aileron so there is a small gap between the

LE of the aileron and the wing. The gap should be small, just

enough to see light through or to slip a piece of paper through.

4. Apply six drops of thin CA to the top and bottom of

each hinge. Do not use CA accelerator. After the CA has

fully hardened, test the hinges by pulling on the aileron.

5. Repeat steps 1-4 for the left wing panel.

Join the Wing

1. Locate the two hardwood wing joiners. Look closely and

you will see that the joiner has a definite angle on the top and

the bottom. The top of the joiner must be facing the top of the

wing when it is installed into the wing in the next step.

2. Test fit the joiner into both wing halves. The joiner

should fit slightly loose to allow room for glue. If the joiner is

snug, sand the face, top or bottom of the joiner as needed

to get a good fit.

3. Temporarily tape the wings together. Place the wing on

the bench. With one wing panel placed flat on the bench,

the other wing should measure approximately 3-3/8"