GREAT PLANES Power Pod Instrukcja montażu - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka GREAT PLANES Power Pod. GREAT PLANES Power Pod 4 stron.

Remove

this area

❑

2. If you are building either the bolt-on or rubber band

version, cut off the bottom of the frame as shown.

❑

3. Glue the front and rear uprights to the main frame.

Drill 1/8"

holes at

the marks

❑

4. If you intend to use the bolt-on method, drill four 1/8" holes

at the punch marks on the base halves.

❑

5. Glue the base halves to the main frame. If you are using the

rubber band version, use the set of bases that has the tabs.

❑

6. Attach the side braces to the uprights and base.

❑

7. If using an electric motor, glue the two motor supports

together and then attach them to the main frame. Glue a small

strip of sandpaper to the supports and the front upright. This will

help keep the motor in position.

❑

8. Install the electric motor into the power pod using two

nylon straps (see photo below).

❑

9. Using two small screws (servo screws work great), attach

the micro switch to the main frame, as shown, in the following

photo. Route the fuse to the back of the pod and secure it in

place using the plywood fuse holder glued to the upright. Attach

the toggle switch to the opposite side brace.

❑

10. Install a micro servo in the plywood servo tray and glue

into the main frame. Set up your radio system so the servo will

actuate the micro switch when the transmitter is at full throttle.