GREAT PLANES SEAWIND RP RX-R Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES SEAWIND RP RX-R. GREAT PLANES SEAWIND RP RX-R 16 stron.

ASSEMBLY

Mount the Motor & Cowl

❏

1. Fit together the assembly/transport stand. Note that the

arrows on the sides point toward the front cradle which is the

one that is shortest. Use foam-safe CA, epoxy or white glue

to glue it together.

❏

2. Test ﬁ t the model in the stand. If necessary, use a hobby

knife to trim the short cradle where shown to ﬁ t the fuselage.

❏

3. Slide the cowl off of the nacelle. Temporarily mount the

prop adapter and the propeller to the motor shaft. Use an 8mm

wrench to tighten the prop nut while holding the collet with a

10mm wrench to lock the prop adapter onto the shaft.

❏

4. Loosen the prop nut and remove the prop and washer.

The collet should remain locked to the motor shaft. If the collet

does not remain locked, use a small drop of CA on the collet

to hold it to the propeller shaft. Then lock it down again.

❏

5. Insert a pin into the motor pod 1/2" [13mm] behind the

middle of the wood block for the top cowl mounting screw.

❏

6. Insert two more pins into the motor pod 1/2" [13mm]

behind the middle of the other two cowl mounting blocks

around the bottom of the motor pod.

❏

7. Fit the cowl to the pod. Mount the propeller with the

prop washer and prop nut.

❏

8. Fit one of the spinners all the way onto the propeller and

collet assembly. Adjust the cowl so there will be approximately

a 1/16" [1.5mm] gap between the spinner and the cowl.

❏

9. Drill a 1/16" [1.6mm] hole through the cowl and the

cowl mounting block 1/2" [13mm] ahead of the pin in the top

of the motor pod–this should put the screw hole right in the

middle of the cowl mounting block. Screw in one of the three

larger wood screws that came with this kit.