GREAT PLANES Silhouette Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES Silhouette. GREAT PLANES Silhouette 16 stron.

❏

3. Slide a wheel onto the main landing gear wire. Insert

the wheel pant on the wire and apply a drop of foam-safe thin

CA to the wheel pant to secure it to the wire. Make sure to

not glue the wheel to the wire.

❏

4. Install the other wheel and wheel pant on the main

landing gear.

MOTOR INSTALLATION

❏

1. Position the RimFire 400 (28-30-950kV) brushless

motor on the motor mount with the wires down. Use the three

3 x 10mm sheet metal screws to mount the motor to the

motor mount. After tightening the screws, remove the screws

and motor and apply a couple of drops of thin CA to the

threads to harden the wood. After the CA has cured, reinstall

the motor.

❏

2. Attach a piece of hook and loop material to the back of

the SS-12 brushless ESC. Route the motor wires through the

hole in the landing gear mount slot and connect the motor

wires to the motor. Route the battery and receiver plug up

through the opening in front of the wing. Attach an opposite

piece of hook and loop material to the bottom of the wing.

Attach the ESC to the hook and loop material on the bottom

of the wing.

❏

3. Plug the ESC into the receiver. Use hook and loop

material to attach the receiver to the top of the wing, inside

the fuselage.

❏

4. Before installing the propeller, temporarily plug the

motor battery into the ESC and check to see if the motor is

rotating in the correct direction.