HiB Demista D2 Instrukcje montażu

Przeglądaj online lub pobierz pdf Instrukcje montażu dla Produkty higieny osobistej HiB Demista D2. HiB Demista D2 2 stron.

Drukuj stronę

Please read through these instructions carefully and refer back to them during installation to

ensure that your product is fitted safely and that it retains its high quality finish.

SELF ADHESIVE

To be placed on back

of mirror

Demista Pad

Article No.

37010

37020

37030

37040

Demista should be mounted directly onto the

mirror back. If required it can be wall mounted with

the use of a suitable adhesive or double sided tape,

but must be in contact with the mirror to achieve

optimal result.

Information Prior to Installation

To avoid damage to the mirror, and in common with normal practice, the following points must be adhered to:

Ensure wall is firm, flat, level and dry.

2. Mirror must be flat across its entire surface at all times to prevent it cracking.

3. Screws must not be over-tightened and must be adjusted evenly to endure mirror is flat.

4. Never rest anything across the mirror surface which will prevent the heat dissipating fully.

5. If Demista is to be installed behind irregular-shaped mirrors or, if the mirror has been weakened in any way, extra care

must be taken not to create any excess stresses.

Demista must not be cut or pierced as this will damage the insulation, rendering it unsafe.

It is recommended that Demista be switched by the light, or dedicated switch. As the ambient room temperature rises, so

will the surface temperature of the mirror.

Demista must NOT be accessible once installed.

The manufacturer or HiB cannot be held responsible for damage caused by improper installation.

Thank you for purchasing this HiB product.

BACK VIEW

To be placed facing

wall

Dimensions

30 x 25cm

30 x 57cm

50 x 53cm

50 x 105cm

Electrical Safety Information

•

HiB recommends that all electrical bathroom products

must be installed in accordance with current building and

wiring regulations.

•

Demista should be connected to the lighting circuit

so that it is activated when the light is switched on,

or to a separate switch if preferred. The circuit must

be protected by a 5amp fuse or circuit breaker at the

distribution board.

•

The wires are coloured in accordance with the following

code:

BLUE = NEUTRAL

BROWN = LIVE OR POSITIVE

•

Wiring must be covered and inaccessible in compliance

with relevant safety standards.

•

LOW VOLT MODELS: These will operate on either AC or

DC supply. Any suitably approved transformer can be

used.

•

MULTIPLE PADS: Several pads fitted to a single mirror

should be wired in parallel. Care must be taken to ensure

that the power supply is sufficient to take the load.

Pads must not overlap as this could cause hotspots and

possible damage to the mirror.

•

All metal parts surrounding the mirror must be earthed

and comply with wiring regulations section 601:18th

edition or equivalent national regulations.

•

The electrical installation must be in accordance with the

latest I.E.E. wiring regulations to BS 7671 or equivalent

national regulations.

•

Power rating - 200 watts/sq.m

FI#01 037 R210730

Fitting Instructions

Demista Pads

Ver No.

1.0 July 2021