Automate 4606A Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Alarm samochodowy Automate 4606A. Automate 4606A 19 stron.

Battery Information (2-Way LED Remote)

The Responder LE remote control is powered by an internal rechargeable bat-

tery that can be serviced only through an authorized Directed dealer. The

information and precautions in this section can help maximize your battery's

life and usage in providing your Responder LE remote control with many years

of trouble free operation.

To charge the battery, connect the provided USB cable between the remote

control and a computer with a USB port. The LED flashes to indicate the re-

mote control is charging. Once full the transmit LED will flash once every two

seconds.

Warnings! NEVER use a cable other than the one pro-

vided or plug into an unspecified source. Injury, severe

damage or explosion may occur when connected to

any other products or used in a way not intended.

Charging the battery when the temperature is below

32°F (0°C) or above 113°F (45°C) may cause

severe battery damage and/or reduce battery life.

Avoid placing the remote control in areas exposed to

extreme cold or heat (direct sunlight) when charging

the battery.

Low Battery

The remote controls constantly monitor the battery's voltage level. If low, a

low voltage alert is confirmed by LED and/or tones. The systems siren/horn

will also emit one extra chirp after disarming to alert of a low battery level

condition.

To check the battery level, press the

tom to top to indicate the current battery charge.

Battery Information (1-Way Remote)

The 1-way remote controls are powered by one 3V coin cell lithium battery

(RPN* CR-2032) that can be purchased at most retailers. When the battery

begins to weaken, the operating range will be reduced.

button five times. The LEDs turn on, bot-