GREAT PLANES Synapse RX-R Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES Synapse RX-R. GREAT PLANES Synapse RX-R 12 stron. Great planes airplanes
Drukuj stronę
INSTALL THE RECEIVER & BATTERY
❏
1. Connect the servos and ESC to the receiver. Install the
receiver and ESC in the locations shown. They can be secured
using small pieces of the included hook and loop material or
double-sided foam servo tape (not included).
❏
13. The receiver antenna can be taped to the side of
the fuselage anywhere that it will not interfere with the duct
channel or canopy. For a clean look, we drilled a 3/32" [2.4mm]
diameter hole from the front of the lower duct channel where
it meets the fuselage up to the radio compartment. Be very
careful not to drill into the duct channel. Feed the receiver
antenna through the hole and out the bottom of the fuselage.
The antenna can then be tucked into the seam between the
lower duct channel and the fuselage. A few drops of thick CA
glue will prevent the antenna from falling out of the seam.
HOW TO CUT HOLES IN FOAM
❏
A. Using a brass or aluminum tube with a diameter of the
size hole you wish to make. Use a rotary tool with a cutoff
wheel to bevel a sharp edge onto one end of the tube. If you
do not have a rotary tool, a hobby knife can also be used to
carve the inside of the tube until the edge is sharp.
❏
B. Press the tube into the foam and twist. The sharp end
will cut a clean hole through the foam without tear out.
❏
3. Use the included hook and loop material to secure the
battery pack in the front of the radio compartment. Test fi t
the canopy hatch onto the plane and confi rm that it fi ts well.
If any of the electric components interfere with the hatch
seating properly, move the components or enlarge the inside
of the compartment or hatch as necessary until it fi ts well.
5