Automate AM2 Instrukcja instalacji - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Alarm samochodowy Automate AM2. Automate AM2 18 stron.
Również dla Automate AM2: Instrukcja obsługi (19 strony)

Drukuj stronę

Transmitter Configurations

The transmitters can be programmed with the standard or single button arm/disarm configurations

by using the Auto Learn functions in the Transmitter/Receiver Learn Routine.

Standard Configuration

A remote that uses the standard configuration operates similarly to many factory keyless entry

remotes. A standard configuration transmitter allows lock/arm, unlock/disarm, and Panic Mode

activation with separate buttons. When programmed for standard configuration using the Channel

1 Auto-learn configuration, the transmitter buttons are assigned to the following functions:

Master Dealer Remotes

A master dealer remote can be programmed into the system for demonstration purposes. Generally,

each salesman would carry a remote that would operate all the cars on the lot equipped with this

system. The dealer remotes(part# 465D) are binary transmitters that are detuned slightly in order

to limit transmitting range. The dealer remote can be taught to the system by following the

Transmitter Learn Routine. When installing the system, it is possible to preset all of the operation

settings using the master dealer remote. However, when the system is operated using the master

dealer remote, a special set of dealer default settings are followed. The dealer default settings are used

to ensure that every vehicle equipped with this system is protected at all times. Only the settings

listed below are affected. When using a master dealer remote, the system operates as follows:

➤ ➤

Passive arming

➤ ➤

Passive locking

➤ ➤

Panic, Valet, and passive arming bypass are disabled

➤ ➤

Security features on

2007

Directed Electronics

operates

and

operate

Lock/Arm only

Unlock/Disarm only

Channel 2 and Silent Mode

Panic only

Channel 3