GREAT PLANES Tori Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Samoloty GREAT PLANES Tori. GREAT PLANES Tori 20 stron.

PREPARATION

❏

1. The canopy is held in place with wire rods at both

ends. To remove the canopy, slide it forward and then lift

the back end up.

❏

2. Use a covering iron with a protective cover sock to bond

areas of loose covering back down to the framework or remove

any wrinkles that may have developed after the covering was

applied. Start with low or medium heat to fi nd the setting that

works best (approximately 275ºF measured on the surface of

the cover sock). Gradually increase the heat as necessary, but

too much heat may cause seams and edges to pull away or

damage the color graphics printed onto the covering, so

proceed with care. As you go, push down on the iron over

sheeted areas to bond the covering to the wood underneath.

❏

3. Stack two or three

paper towel squares on

top of each other and

cut them into small

squares. These squares

may

dampened

with denatured alcohol

when epoxy cleanup is

needed.

You can assemble one wing at a time, or work on both wing

halves simultaneously. The left wing is shown in the photos.

❏

1. Cut the covering from the wing over the wing bolt

holes, the leading edge dowel holes and the servo wire

holes in both wing halves.