Automate ValveLink 8 Podręcznik użytkownika - Strona 15
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Router sieciowy Automate ValveLink 8. Automate ValveLink 8 16 stron.
Drukuj stronęEPROM Installation Instructions
1) Open the ValveLink case as described in the preceeding
paragraph. Re move the last EPROM
slowly with a fl at screw driv er or IC
re mov er noting the 'dimple' ori en ta tion
(pin 1) on its left side. Insert the new
chip with the same orientation – being
careful not to bend any pins.
2) Make sure that the ValveLink turns on, then turn it back
off before reinstalling the case top. Save the old EPROM until you
are completely satisfi ed with the new one.
EPROM's can be erased and recycled, and they cost around
$3.99 each. So if you're happy with an upgrade, it's worth the few
pen nies stamp cost for U.S. cus tom ers to drop them in an envelope
back to AutoMate. International (or busy U.S.) customers will be
excused if they cannot return old [useless] eproms. :-)
24
©2003 AutoMate Scientifi c
ValveLink
1.3 ___
The following instructions pertain to the risk of fi re, electric shock, or bodily
injury. Please read all of these instructions care ful ly.
1. Follow all the instructions and warnings marked on this prod uct or included
in this manual.
2. Do not use this product on an unstable cart, stand, or table. This product
may fall, causing serious damage to the prod uct.
3. Slots and openings in the cabinet and the back are pro vid ed for ven ti la tion.
To ensure the reliable operation of your product, and to pro tect it from overheating,
these openings must not be blocked or covered. Do not use this product on a bed,
sofa, rug or other similar surfaces. This product should never be placed near or over
a radiator or heat register. This product should not be placed in a built-in in stal la tion
unless proper ven ti la tion is provided.
4. Never push objects of any kind into the product through the cab i net open-
ings, as they may touch dangerous voltage points or short-out parts that could result
in fi re or electric shock. Nev er spill liquids of any kind in the product.
5. This product should only be connected to the AC power source in di cat ed on
your product system's information label. If you are not sure of the type of AC power
available, consult your dealer or local power com pa ny. Only connect this product to
a power outlet that matches the power re quire ments of this prod uct.
6. Do not allow anything to rest on the power cord. Do not locate this product
where people will walk on the cord.
7. If you have to use an extension cord with this product, make sure that the
total amperage rating of all equipment plugged into it does not ex ceed the amperage
rating of the ex ten sion cord. Also, make sure that the total of all products plugged
into the main AC power outlet does not exceed 15 Amps.
8. Unplug your product from the main electrical power be fore clean ing. Do
not use liquid cleaner or aerosol cleaners. Use a damp cloth for cleaning.
9. Do not use this product near water.
Safety Instructions
25