Automated Logic InterOP8500 Instrukcje techniczne - Strona 19

Przeglądaj online lub pobierz pdf Instrukcje techniczne dla Jednostka sterująca Automated Logic InterOP8500. Automated Logic InterOP8500 20 stron.

Drukuj stronę

LED 24 Output Power - indicates power is

being received from field termination board

from the external power supply for binary

outputs and isolated binary inputs.

Table 10. LED Signals

Run LED

Error LED

2 flashes

Off

per second

2 flashes

1 flash,

per second

then pause

2 flashes

2 flashes,

per second

alternating

with Run

LED

2 flashes

2 flashes,

per second

in sync

with Run

LED, then

pause

2 flashes

3 flashes,

per second

then off

2 flashes

4 flashes,

per second

then pause

2 flashes

per second

5 flashes

per second

5 flashes

Off

per second

7 flashes

per second

per second,

alternating

with Run

LED

14 flashes

per second

per second,

alternating

with Run

LED

Revised 7/10/01 • InterOP8500

Condition

Normal

Normal, but module is

alone on the CMnet

(this sequence doesn't

occur in WebCTRL)

Five minute auto-restart

delay after system error

Module is configured for a

different baud rate than the

rest of the network

segment

Module has just been

formatted

Two or more devices on

this network have the

same ARC156 network

address

Exec halted after frequent

system errors or GFBs

halted

Exec start-up aborted, Boot

is running

Firmware transfer in

progress, Boot is running

Ten second recovery

period after brownout

Brownout

Protection

The InterOP8500 module is protected by

internal solid state Polyswitches on the

incoming power and network connections.

These Polyswitches are not replaceable and

will reset themselves if the condition that

caused the fault returns to normal.

Production Date

To determine when a module was

manufactured, check the module status

report for the module in WebCTRL or

SuperVision. Refer to the appropriate user's

guide for more information about the module

status report.

A sticker on the back of the module also

shows the date the module was

manufactured. The first three characters on

the sticker indicate the type of module. The

next two characters show the year and month

of manufacture.