Automated Logic U141v+ Instrukcje techniczne - Strona 4

Przeglądaj online lub pobierz pdf Instrukcje techniczne dla Systemy kontroli Automated Logic U141v+. Automated Logic U141v+ 12 stron.

Drukuj stronę

Start-Up Checklist

1. Use the appropriate version of Eikon for

WebCTRL or Eikon 3.0a or later to create

GFBs for U-Line modules. Be sure to

enable the Zone GFB option in Eikon for

WebCTRL or Eikon. Refer to "Writing GFBs

for the U141v+" on page 9 for more

information.

2. Use the appropriate module driver. (See

"Job Start-Up" on page 3.)

3. Connect the U-Line modules to the Unet

and the UNI.

4. Transfer the U-Line modules' GFBs to the

UNI.

Mounting

It may be necessary to re-position the motor

assembly to mount the U141v+ properly.

• Remove the U141v+'s cover.

CAUTION The circuit board is not

attached to the card housing. Take care

when removing the cover.

• Use a Phillips #2 or Torx 20 screwdriver

to detach the motor assembly from the

card. Re-position the assembly, taking

care to re-route the cable attaching the

assembly to the circuit board. Re-attach

the assembly and replace the module's

cover.

1. Place the module on the VAV box by

feeding the damper shaft through the

shaft slot (see Figure 2).

VAV BOX

D a m p e r S h a f t

Figure 2. U141v+ Placement on VAV Box

Revised 8/14/02 • U141v+

CAUTION Do not position the module

so that the shaft slot is in the upper right

of the module (see Figure 3). This position

may cause condensation from the VAV

shaft to drip on to the electronic

components of the U141v+.

Figure 3. Improper Mounting Position

2. Position the damper shaft and motor in

the desired position, then tighten the shaft

clamp (see Figure 4).

3. Insert a mounting screw into the

stabilizing slot and tighten it to secure the

module (see Figure 4).

Shaft Slot

F e e d t h e d a m p e r

s h a f t t h ro u g h

t h e m o d u le 's s h a f t s lo t

Addressing

The U141v+ has dual rotary switches for

assigning the board address. The top switch

corresponds to the tens digit and the bottom

switch corresponds to the ones digit (see

Shaft Clamp

U TOM A TED

OGI C

BACnet

MS/TP

Flow

Figure 4. Mounting Slots

Stabilizing Slot