Automated Pet Care Products LITTER-ROBOT Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla Produkt do pielęgnacji zwierząt domowych Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 16 stron. Self-cleaning litter box
Również dla Automated Pet Care Products LITTER-ROBOT: Podręcznik (18 strony), Podręcznik użytkownika (19 strony)

Drukuj stronę

Automated Pet Care Products, Inc.

Safety Features

Cat Re-entry Protection Mode

If your cat tries to enter the Litter-Robot and

activates the cat sensor during a clean cycle, the

globe will stop rotating, wait for 15 seconds and

then attempt to resume the clean cycle. If the

cat sensor continues to be activated the globe

will not turn.

Note:

The Cat Re-entry Protection Mode is not

activated during the initialization cycle (first

cycle after plugging in the power cord).

Globe/Motor jammed or obstructed

If the globe becomes jammed the motor will

stop and all three lights on the control panel will

blink at a rate of twice per second.

•

Unplug the power cord

Remove the obstruction

•

Reposition the globe in the home

•

position

•

Plug the power cord back in

If the condition persists, please call Customer Service

toll-free at 1-877-250-7729.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Automated Pet Care Products, Inc.

Cleaning & Maintenance

The Litter-Robot requires no special maintenance. It is

recommended that you do not lubricate the Teflon glide

buttons on the base unit. Lubricating these glide

buttons will allow dirt to build up.

Before you clean the Litter-Robot please make sure that

you remove all litter from the globe - wet litter turns into

messy clay.

To remove all litter, press the "Empty" button on the

Control Panel. The globe will rotate clockwise and all

litter will be discharged into the waste drawer.

Globe

After removing litter from the globe, clean with

water and a mild soap. There are no electronic

components in the globe which can be damaged by

soap and water.

Drawer

The drawer can be removed and cleaned with soap

and water.

Base

Never submerge the base. Wipe surfaces of base

with a cloth dampened with a disinfectant. The Cat

Sensor Switch (located at the front of the base

under the drawer) can get contaminated with litter

or dust. The Trouble Shooting section shows how to

clean the contacts of this switch with WD-40™.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797