DAYTEK HOMEBUILDER Instrukcja montażu

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wózek zewnętrzny DAYTEK HOMEBUILDER. DAYTEK HOMEBUILDER 2 stron.

WHEEL

1. PLACE WHEELBARROW BOWL UPSIDE DOWN OVER A BENCH OR TABLE EDGE.

2. ASSEMBLE HANDLES "A" INTO FRONT FRAME "B" AS PER DIAGRAM. LOCATE ASSEMBLY OVER THE HOLES IN THE

BOWL. INSERT 2 x LONG BOLTS FROM INSIDE THE BOWL AT POSITION 1 AND FINGER TIGHTEN WITH WASHERS & NUTS.

3. ASSEMBLE LEGS "C" TOGETHER IN A CROSS-PATTERN AT POSITION 2 WITH 1 x SHORT BOLT AND FINGER TIGHTEN

WITH WASHER & NUT.

4. LOCATE THE LEGS OVER THE BOWL AS SHOWN AND FIX WITH 4 x LONG BOLTS AT POSITION 3 & 4. FINGER TIGHTEN

WITH WASHERS & NUTS.

5. ASSEMBLE THE 2 STRUTS "D" TO THE FRONT OF THE BOWL AND FINGER TIGHTEN ONLY.

CAUTION!

PRESSURE. ENSURE SQUARE NECK OF BOLTS ARE LOCATED IN BOWL

DURING ASSEMBLY.

TIP

IN POSITION DURING ASSEMBLY. USE A MALLET TO KNOCK COMPONENTS

INTO POSITION IF NEEDED.

BOWL

– INFLATE TYRE WITH CARE. DO NOT EXCEED RECOMMENDED

– PLACE STRONG TAPE OVER THE HEAD OF THE BOLTS TO HOLD THEM

X11

v1.0

AXLE x1

AXLE SPACER

AXLE

BRACKET