Daytona DJS22T Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Walety Daytona DJS22T. Daytona DJS22T 9 stron. 22 ton jack stands with locking pin
Drukuj stronę
Specifications
IMPORTANT SAFETY INFORMATION
1. Study, understand, and follow all instructions
before operating this device.
2. Use only as an identical pair.
3. Maximum load capacity per identical pair shall not
exceed the rated capacity of the individual stand.
4. Use stands to support one end of a vehicle only.
5. Use only on a hard, level surface
capable of supporting the load.
6. Center load on saddle.
7. Locate saddles at vehicle manufacturer's
designated support points.
8. Failure to heed these markings may result in
personal injury and/or property damage.
9. No alterations shall be made to this product.
10. Stands are not to be used to simultaneously
support both ends of a vehicle.
11. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
12. Do not use for aircraft purposes.
13. Do not exceed listed weight capacity.
Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing product failure.
14. Inspect before every use; do not use
if parts loose or damaged.
15. Examine Jack Stands for cracks or damage
before each use. Do not use if even a minor crack,
bend or other damage/deformation appears.
Discard Jack Stand if damaged or deformed.
16. Keep work area clean. Cluttered areas invite injuries.
17. Observe work area conditions.
Keep work area well lighted.
Page 2
Capacity
Height Range (Approximate)
Saddle Size
*Evenly distributed across two Jack Stands.
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
22 Tons (44,000 lb.)*
13-7/8" – 19-7/8"
(3" increments)
3" x 3-3/4"
18. Keep children away. Children must
never be allowed in the work area.
19. Store idle equipment. When not in use, tools must
be stored in a dry location to inhibit rust. Always
lock up tools and keep out of reach of children.
20. There are certain applications for which this tool was
designed. Do not modify this tool and do not use this
tool for a purpose for which it was not intended.
21. Dress properly. Do not wear loose clothing or jewelry
as they can be caught in moving parts. Protective,
electrically non-conductive clothes and non-skid
footwear are recommended when working. Wear
restrictive hair covering to contain long hair.
22. Maintain tools with care. Keep tools clean for
better and safer performance. Follow instructions
for lubricating and changing accessories.
23. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
24. Stay alert. Watch what you are doing, use common
sense. Do not operate any tool when you are tired.
25. Do not operate tool if under the influence of
alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment
or reflexes are impaired while taking drugs. If
there is any doubt, do not operate the tool.
26. Only use on proper surface. Only use the Jack
Stands on a dry, level, flat surface, which is free
of grease or debris. The surface to be used
must be capable of supporting the combined
weight of the vehicle and the Jack Stands.
27. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.
Item 58623