Emergi-Lite X10 Steel Series Podręcznik
Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt oświetleniowy Emergi-Lite X10 Steel Series. Emergi-Lite X10 Steel Series 2 stron. Self powered led exits
Drukuj stronęX10 Steel Series - Self Powered LED Exits
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Use caution when handling batteries. Avoid possible shorting.
5. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
6. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
7. Do not use this equipment for other than intended use.
8. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Route AC unswitched circuit of rated voltage into electrical box and
leave 6" of wire length.
3. Remove exit face. To open the sign, remove screws from the end cap
(See Fig. 1) and slide out the exit face and the fibreglass diffuser.
4. Remove the appropriate chevron(s) on the exit sign by supporting the
exit face either side of the chevron and knock out carefully with a
screwdriver from the rear (See Fig. 2).
Wall Mount
a. Knock out the proper hole pattern in the back plate to mount to
the standard junction box (including the large wire hole); place a
support on either side of the hole to be removed and knock out
with a screwdriver.
b. Feed AC supply leads through the center hole.
c. Mount the exit sign securely to the junction box using the junction
box screws (See Fig. 3).
Emergi-Lite
Tel: (888) 552-6467
Figure 1
Part List
1. Junction box (existing)
2. Spider Plate
3. Canopy
4. Housing
5. Kep Nuts (2)
6. LED Strip
7. Junction box screws (not
provided)
Figure 2
Figure 3
Fax: (800) 316-4515
www.emergi-lite.com
X10 Steel Series - Self Powered LED Exits
8. Screws #8-32 x 3/8" (2)
9. Screws #8-32 x 1-1/2" (2)
10. Exit face
11. Back Plate (or second exit
face)
12. Diffuser Panel
13. End Cap
14. End cap screws (2)
05/10 750.1273 Rev. D
1/2