Daytona DTJ10T Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Walety Daytona DTJ10T. Daytona DTJ10T 8 stron. Heavy duty hydraulic toe jack
Drukuj stronę
Maintenance and Servicing Instructions
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Do not use damaged equipment.
If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. Before each use, inspect the general condition
of the Jack. Check for broken, cracked, or bent
parts, loose or missing parts, and any condition that
may affect the proper operation of the product. If a
problem occurs, have the problem corrected before
further use. Do not use damaged equipment.
2. Before each use, thoroughly test the Jack for
proper operation prior to its actual use. If the
Jack appears not to be working properly, have
the problem corrected before further use.
3. Before each use, check oil level:
a. Lower the Jack to its lowest position. Follow
instructions on lowering Jack on Page 4.
b. With the Jack upright in a level, vertical position
and the Handle pointing down in the Fulcrum,
carefully remove the Oil Fill Plug. The oil level
should be level with the bottom of Oil Fill hole.
Top off if necessary but do not overfill. Always
fill with clean hydraulic jack oil (not included).
WARNING! TO PREVENT SERIOUS INJURY:
Make sure no contaminants enter the Reservoir
when filling with oil. Never use any oil other
than hydraulic jack oil to fill Reservoir.
Troubleshooting
Problem
Toe will not extend.
Jack will not lift
to full height.
Toe extends but
falls immediately.
External Oil Leak.
Follow all safety precautions whenever diagnosing or servicing tool.
Do not lift anything with Jack while servicing.
Item 57664
Possible Causes
1. Release Stem is open.
2. Debris in Valve Sealing Section.
3. Crack in Valve Sealing Section.
1. Too much hydraulic jack
oil in Reservoir.
2. Not enough hydraulic
jack oil in Reservoir.
1. Air in system.
1. Damage to Reservoir,
Release Stem, or Pump.
For technical questions, please call 1-888-866-5797.
c. Reinstall Oil Fill Plug. Check Jack operation.
Bleed air from system as needed.
4. Change the hydraulic oil at least
once every three years:
a. With the Jack fully lowered, remove the
Oil Fill Plug on the side of the Housing.
b. Tip the Jack to allow the old hydraulic oil
to drain out of the Housing completely,
and dispose of the old hydraulic oil in
accordance with local regulations.
c. With the Jack upright, completely fill the Housing
with a high quality hydraulic oil (not included) until
the oil just begins to run out of the Oil Fill hole.
d. Then, reinstall the Oil Fill Plug and check jack
operation. Bleed air from system as needed.
5. Clean with a clean cloth with a detergent
or mild solvent. Then, store the Jack in a
safe, dry location out of reach of children
and other non-authorized people.
Likely Solutions
1. Close Release Stem completely.
2. Clean Valve Sealing Section.
3. Repair or Replace Valve
Sealing Section.
1. Remove excess oil and fill
with correct amount.
2. Top off with hydraulic jack oil to
the bottom of the Oil Fill Hole.
1. Press Ram down to lowest
position and let air out of Reservoir
by pushing Fill Plug sideways.
1. Repair or Replace damaged part.
Page 5