Automatic WTLD018 Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Automatic WTLD018. Automatic WTLD018 16 stron. 20v drill/driver
Drukuj stronęBattery Indicator Under No-load
Red
Orange
LED
LED
ON
ON
ON
ON
ON
OFF
2 Speed gearbox
The 2 Speed Gearbox allows you
to select a gear with the optimum
speed and torque to suit the
application.
Note. When changing the drill
selector ensures the drill is not
operating.
To select the LOW gear (low
speed, high torque setting), push
the gear selector (9) backward,
towards the back of the drill. The
symbol "I" will be displayed.
To select the HIGH gear (high
speed, low torque setting), push
the gear selector (9) forward,
towards the chuck.
The symbol "II" will be displayed.
Green
Battery status
LED
indicator/description
ON
High: Battery is fully charged
OFF
Medium: Battery Approx 50% charge capacity.
OFF
Low: Battery has less than 30% charge capacity and should be charged.
WARNING: Never use a damaged battery pack.
Using the drill
Trigger switch
Use the forward/reverse switch
(4) to select the direction of
rotation, then pull the trigger
(3) This trigger switch is an
electronic variable speed control
which enables the user to vary
the speed continuously. The speed varies according to
how far the trigger switch is depressed. The further it is
depressed the faster the chuck will rotate and the lighter it is
depressed, the slower it will rotate.
To stop the drill, release the trigger switch.
Note. The variable Speed control fitted to this drill is NOT
intended to be used for long periods of time during the
operation of the task being performed. Use the variable
speed to start drilling and screwing tasks, and then fully
depress the trigger once the task has started.
CAUTION. Extended use of the variable speed under load will
overload and then permanently damage the speed control.
12