HIBLOW hp-150 Podręcznik - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik dla Pompa wodna HIBLOW hp-150. HIBLOW hp-150 8 stron. Air pumps
Również dla HIBLOW hp-150: Instrukcja obsługi (13 strony), Instrukcja obsługi (17 strony)

Drukuj stronę

HP- 150 / 200

STEP

Remove 2 U-lock nuts from one side holding the

diaphragm mounting block to the rod.

●Use the nut driver to loosen (or tighten) the U-lock nut.

STEP

Remove one of the diaphragm mounting blocks

from the actuating rod and pull out the other

diaphragm mounting block with the rod. After

that, separate the diaphragm mounting block and

the rod.

●When pulling out the rod, be sure not to catch the rod

projection on the lever of the SP switch.

●If the pump stops automatically, the safety pin must be broken to prevent any

further damage to the pump. Be sure all broken pieces are removed from the unit.

(See Step 14)

STEP

REPLACING THE DIAPHRAGM

In case of replacing the whole diaphragm

mounting block, move straight to

Remove the diaphragm ring from the diaphragm,

and then, detach the diaphragm from the

diaphragm base.

STEP

Fit a new diaphragm and diaphragm ring in the

diaphragm base.

●Be sure not to leave a gap between them.

REPLACING THE CHAMBER BLOCK

STEP 11