Automatic Solutions ABK Instrukcja instalacji i obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla System interkomu Automatic Solutions ABK. Automatic Solutions ABK 17 stron. Gsm intercom system

Drukuj stronę
Now that the GSM part of the intercom is programmed and working, you may now program the
keypad. The keypad is programmed directly on the keys, not remotely by SMS.
This keypad has 3 outputs. The diagram below shows the LED indicators which indicate
programming and relay status information.
ON when incorrect codes entered and outputs are locked out.
1
2
3
4
5
6
7
8
9
*
0
#
TIP: After power up, as a security precaution, the keypad cannot be programmed for 60 seconds.
Once this time elapses, you may begin.
TIP: Flashing amber LED is normal standby mode!
Quick start guide
1) Enter programming mode (amber LED should be ON)
0
0
0
0
2) Enter a new user code...
1
0
2
0
0
3) Exit programming mode
*
*
4) Enter the new user code to check the relay clicks.
Enter programming mode..
0
0
0
0
Exit programming mode..
*
*
P a g e
| 10

Keypad overview

GREEN when output 1 activated.
RED when output 2 activated.
FAST FLASHING – Wrong code entered / error.
SLOW FLASHING - in normal standby mode.
ON in programming mode.
ON when relay 3 activated.

Basic Keypad Programming

*
*
0
?
?
?

Full Keypad programming

The unit is now in programming mode. Amber LED on the
*
*
keypad should remain permanently on. 0000 is the default
programming passcode.
The unit should exit programming mode and the amber LED
should start flashing again.
?
#
Tip: The engineer code
must be the same length as
user codes. So if using a 6
digit engineers code, then
user codes must also be 6
digits long etc.