DaytonAudio ME652C Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Głośniki DaytonAudio ME652C. DaytonAudio ME652C 4 stron. Micro edge series dual-channel ceiling speaker

Drukuj stronę
9)
Troubleshooting
Should your speakers not work properly, check the following:
No sound from speakers:
G
Most stereo receivers have an A/B speaker selector switch. Make certain that
this switch is in the proper position.
G
Mute feature is activated.
One speaker is playing while the other is not:
G
Check the balance control on the receiver. Make sure it is centered.
G
Loose connection at either the receiver or the speaker. Double check connections.
G
Bad speaker cable. Replace suspect speaker cable.
Receiver cuts on and off:
G
This could be caused by a short circuit between the positive and negative leads.
Check the connections at the back of the receiver, and then at the speaker; make
sure that no strands of wire from one connector are touching the other connector.
10) Caring For Your Ceiling Speakers
The two most common ways that ceiling speakers are permanently damaged:
1)
Not enough power at higher volumes.
2)
Too much power at higher volumes.
Contrary to conventional wisdom, more speakers are damaged as a result of under-powering, than
by overpowering. When a receiver runs out of power, it still tries to reproduce the musical signal by
"clipping" the waveform. At high volume levels this clipping introduces gross amounts of distortion
to the speaker, eventually destroying it. If the sound from your ceiling speakers starts to sound
distorted, turn down the volume.
Having plenty of reserve power will help your speakers reproduce dynamic contrasts and quick tran-
sients of music much more effectively, but you must exercise good judgment; too much power can
also permanently damage a speaker. If you hear distortion, turn the volume down.
Dayton Audio
®
Specifi cations
Model number
Woofer
Tweeter
Frequency response (Hz)
Dimensions H x W x D (in)
Cut-out size H x W (in)
Power handling (RMS/Peak)
Impedance
SPL (1W/1m)
Xover point (Hz)
Xover slope
5-Year Warranty
See daytonaudio.com for details
daytonaudio.com
tel + 937.743.8248
ME652C
6.5" DVC Kevlar
1" Silk x 2
50-20,000
9-3/4" dia x 4"
8-1/4" dia.
35/70
8 + 8 ohm (dual)
88 ±3dB combined
3,000
12dB/octave
705 Pleasant Valley Dr.
Springboro, OH 45066
USA
Last Revised: 3/6/2017