DaytonAudio WP8BT Podręcznik użytkownika - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Głośniki DaytonAudio WP8BT. DaytonAudio WP8BT 4 stron. 8” ip55 indoor/ outdoor pendant speaker 70v/100v with 8 ohm bypass
Drukuj stronę
Thank you for purchasing the Dayton Audio
speaker is designed to deliver reliable, high-quality audio in commercial and residential
applications, while withstanding outdoor environments. The WP8 features an IP55 weath-
er-resistant ABS construction, 2-way coaxial speaker design.
• 8" woofer with coaxial 1" tweeter
• Integral 70V/100V transformer with selectable taps and 8 ohm bypass
• Suitable for indoor or outdoor installation
• Available in black or white finish
Please read these instructions completely before you begin your installation.
1) Speaker Connection
Remove about 8" of the cable jacket to expose the inner conductors. Strip 1/4" of in-
sulation from each conductor and connect to the speaker terminals. When connect-
ing the wires to the speakers, be sure to observe proper polarity for the best sound.
Most CL2 rated speaker cable will have red and black colored wires inside the
jacket. Connect the red wire to the (+) terminal and the black wire to the (-) terminal.
The red (+) and black (-) speakers wires should correspond to the same terminals
on the amplifier.
NOTE: If this speaker will be used with a 70V/100V distributed audio system, do
not set the 70V/100V tap to the 8 ohm setting. Doing so may damage your speaker
when playing. To use this speaker with a conventional (non-70V/100V) audio sys-
tem, change tap to the 8 ohm setting. If you are unsure what type of audio system
you have, consult a professional installer before continuing.
Step 1: Remove the speaker end cap
Using a screwdriver or other flat-blade tool, turn the tap selector knob to the desired
setting. Selecting the 8 ohm setting will remove the transformer from the signal path
and allow a conventional amplifier to drive the speaker. If using a 70V/100V system
choose the appropriate output setting for the application.
Step 2: Reinstall speaker end cap
Once you have selected the correct setting and mounting bracket you can feed the
speaker wire through the end cap and reinstall.
Typical 70V/100V installation wiring method
8" pendant speaker.This rugged, all-purpose
®
2