GAI-Tronics Titan CB Instrukcja instalacji i obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Telefon GAI-Tronics Titan CB. GAI-Tronics Titan CB 20 stron. Weather resistant telephones

GAI-Tronics Titan CB Instrukcja instalacji i obsługi
3.
The Titan telephone is intended for vertical installation to a wall or pole.
Select the required mounting method (section 5) and mount the rear
enclosure first where applicable.
4.
Route the required cables through glands as appropriate, and make
connections and option settings following section 6.
5.
Re-fit the faceplate ensuring a weatherproof seal
6.
Test the operation of the telephone (section 3). Installation is now
complete.

4.4. Commander

1.
All connections and option settings are on the lower edge of the circuit
board housed in the rear casing.
2.
To prepare for installation, undo the three retaining screws shown to
remove the front casing from the rear. The screws are captive in the
front casing; a 5mm Allen key is required. Disconnect the handset /
hookswitch connector(s) from the circuit board, noting the position and
orientation.
3.
The Commander telephone can be installed vertically to a wall or pole,
or used horizontally on a desk. Select the required mounting method
(section 5) and mount the rear casing first where applicable.
4.
Route the required cables through glands as appropriate, and make
connections and option settings following section 6.
5.
Reconnect the handset / hookswitch. Re-secure the telephone Front
Casing to the Rear Casing with the three retaining screws, ensuring a
weatherproof seal.
6.
Test the operation of the telephone (section 3). Installation is now
complete.
5.

Mounting methods and dimensions

5.1. General

Installation details differ between the TITAN and COMMANDER product
ranges –please make sure you know which product you are installing
and refer to the appropriate sections below.
Before mounting the telephone, check the cable routing and requirements. If
glands are required, fit them to the case as follows:
1. Remove the RED blanking plug leaving the other (usually BLACK) in
place.
Titan CB, Commander CB
IMPORTANT
7