GAI-Tronics 370-202 Instrukcja montażu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wzmacniacz GAI-Tronics 370-202. GAI-Tronics 370-202 10 stron. Electro-sound interface amplifier
Drukuj stronęPub. 42004-374A
Model 370-202 Interface Amplifier Assembly for Electro-Sound
Page: 3 of 9
Wiring a Model 370-202 Between a Page/Party
System and an Electro-Sound II System
®
®
Figure 2 shows the wiring of a three-wire Electro-Sound system interfaced to a five-party Page/Party
system. Handsets or headsets plugged into jack stations are normally tied to party line 5 but switch to the
page line whenever the page switch on the handsets or headsets is pushed. The power source contains a
relay that disconnects the coupling when no handset or headset is plugged in and another relay for
switching between page and party lines.
The wiring shown in Figure 2 provides ac power to Model 471 Electro-Sound Power Source, Model 370-
®
202 Interface Amplifier Assembly, and Page/Party
wall stations.
The wiring to the interface shown in Figure 2 can be modified for two-wire Electro-Sound systems. See the
Electro-Sound installation manual, 42004-072. It is absolutely necessary to place a 33-ohm load between
points four and five or between points six and seven on the power source enclosure terminal blocks if these
points are not connected to a page or party system. The two-way amplifier in the Model 370-202 may
®
oscillate if these resistors or the Page/Party
Line Balance Assembly is not connected to the Model 370-
202 Interface.
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-374a.doc
07/05