DayTronic M2 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe DayTronic M2. DayTronic M2 20 stron.

4. Setting up the device

Menu level

Parameterisation level

Administrator code / Master code (4-digit number-combination free available),

A.Co:

With this code all parameters can be re-activated, after LOC has been activated under

menu item run before. By pushing [P] in operation mode for approx. 3 seconds, CodE

occurs in the display and enables the user to reach all parameters by entering the

A.co. While leaving the parameterisation under run, the parameterisation can be

activated permanently by selection of ULC. So that at a renew pushing of [P] in

operating mode, no new entering of the code needs to be done.

Activiation / Deactivation of the programming interlock or closing-off of the

parametrisation, run:

With the navigation keys [▲] [▼], one can choose between the deactivated key lock

Uloc

Loc

(works setting) and the activated key lock

. Confirm the selection with [P].

- - - - -"

After this, the display confirms the settings with "

, and automatically switches to

Loc

operating mode. If

was selected, the keyboard is locked. To get back into the

CODE

menu level, press [P] for 3 seconds in operating mode. Now enter the

(works

1 2 3 4

FAIL

setting

) that appears using [▲] [▼] plus [P] to unlock the keyboard.

appears if the input is wrong. By pressing [P] in operation mode for approx. 3

seconds, the first menu group adr appears in the display and thus confirms the

change into parameterisation. It stays activated as long as ULOC is entered in menu

group RUN, thus the display is set back in standard parameterisation again.