Automatic Technology GDO-8 Shed Master Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Otwieracz drzwi garażowych Automatic Technology GDO-8 Shed Master. Automatic Technology GDO-8 Shed Master 20 stron. Weather resistant roll up door opener
Również dla Automatic Technology GDO-8 Shed Master: Instrukcje instalacji (2 strony)
Drukuj stronę
8. Coding Transmitters
Press and
hold
Fig. 8.3
Fig. 8.4
®
GDO-8 ShedMaster
8.3 To Erase Programmed Codes
a. Select the transmitter you want to delete.
b. Press and hold the DOOR CODE BUTTON
(Fig. 8.3).
c. Press the transmitter button you would like to
delete for two seconds, pause for two seconds,
press again for two seconds and then release.
Release the DOOR CODE BUTTON. The opener will
beep two times. The code should now be deleted.
Confirm this by pressing the transmitter button - the
function (e.g.
door opening) should not respond.
8.4
Remotely Coding Transmitters
Using this method transmitters can be coded without
access to the opener's control panel as long as a
pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button
for the function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly
for two seconds the middle button, through the
(Fig.
Coding Hole
c. Within ten (10) seconds take the additional
transmitter you wish to code.
transmitter's button for two seconds, pause for
two seconds, hold again for two seconds and then
release.
d. Wait for ten (10) seconds and then press the new
transmitter's button to test.
Home Owner's Manual
8.4).
Hold the new
11