DynaGen BCM-12 Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Ładowarka DynaGen BCM-12. DynaGen BCM-12 14 stron. Battery charge monitor

WIRING INSTALLATION GUIDELEINES

Danger: Never work on the engine while its power is on. This

Battery Charge Monitor does not generate a warning signal prior to

automatic engine start. Warning signs should be placed on engine

equipment indicating this important safety measure.

Following these instructions will help avoid common installation problems during wiring and

setup.

• Battery (Terminal 1 & 2) must be disconnected before any wiring connections are made.

Battery disconnection can easily be accomplished by removing terminal block from BCM

unit.

• Wire length from the BCM unit to operating equipment, should not exceed 30 feet. Longer

runs may require the use of heavier gauge wiring.

• Do not connect high voltage AC circuits to the BCM unit.

Wiring size should be minimum 18AWG. Use stranded wire, since solid wire has a tendency to

crack, break and loosen over time.

NOTE:

• When making connections to BCM's removable terminal block, ensure that there are no wire

strands that are exposed. Exposed strands may cause shorting to adjacent wiring terminals.

• Ensure that wire connections to removable terminal block are securely fastened, since

vibrations have a tendency to loosen wiring connections over time.

Terminal

Wire Size

14 – 18

Operating & Installation Manual for Battery Charge Monitor (BCM)

Current Max.

10A

0.1A

N/C

Function

Battery positive (+)

Battery negative (-)

Start/Run Relay output

Sensing Input

N/C