DynaGen GSC400 Series Podręcznik programisty - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik programisty dla Płyta główna DynaGen GSC400 Series. DynaGen GSC400 Series 4 stron. For generator
Również dla DynaGen GSC400 Series: Instrukcja obsługi narzędzia kalibracyjnego (18 strony)
Drukuj stronę
2. Disconnect the GSC400 Programmer from the computer.
3. Go to the Control Panel in the Start menu. Double click on "Add and Remove
Programs".
4. Scroll down to "FTDI USB Serial Converter Drivers" and click "Change/Remove".
5. The FTDI Uninstaller window will appear. Follow the instructions.
Changing the USB Serial Port (Vista, Windows XP, 2000).
1. Click on the Start Menu at the bottom left hand corner of your screen and right click on
"My Computer". Click properties at the bottom of the list. Select the Hardware tab and
under the "Device Manager" section click the "Device Manager" button.
2. The Device Manager window will appear.
3. Scroll down to "Ports (COM & LPT)". Expand and you should see "USB Serial Port".
Right click and select "Properties" at the bottom of the list.
4. A dialog box "USB Serial Port Properties" will appear. Click on the "Port Settings" tab.
Click the "Advanced" button and a window will appear allowing you to change the
comm. port at the top left hand corner of the window. Select the appropriate comm. port
and then click OK at the right. Not that some comm. ports may be in use. This will be
indicated by "(in use)" beside the comm. port. Sometimes a comm. port may be
indicated in use even when it is not so. Make sure that no connected device is using the
com. Port before making your selection.
5. Click "OK" button on the "USB Serial Port settings" Then close the "Device Manager"
window.
6. You will now be able to use the comm. port you selected to communicate to the GSC400
Programmer via USB.
Setting up the Programmer to Update Settings.
1. Make sure power to the controller is off. Connect the GSC400 Programmer to the
computer using a serial or USB cable.
2. Connect one end of the 10pin ribbon cable to the controller, red side facing towards the
center of the controller. Connect the other end of the 10pin ribbon cable to the GSC400
programmer with the red side of the cable facing the push button. You will need to attach
the two enclosed female to female 10pin headers to both ends of the cable.
3. Make sure that the slide switch on the GSC400 Programmer is in the off position. The on
position is indicated on the switch. Power up the controller. The controller display
should be on.
4. You can now communicate with the controller via the PC.
GSC400 Programmer Manual
Revision 1.0 (22/12/2006)
4