Dayva HS041-2 Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka Dayva HS041-2. Dayva HS041-2 19 stron. Premier outdoor heater

DAYVA PREMIERE OUTDOOR HEATER

TROUBLE SHOOTING

PROBLEM 3

Ignitor not lighting pilot

CAUSE

Electrode not creating a sufficient enough spark to

ignite the gas

SOLUTION

CHECK SPARK GAP AND ELECTRODE

CONNECTIONS

1. Remove the hood and emitter by removing the (4)

screws that attach the emitter screen to the burner

plate.

2. Check the spark gap and adjust as illustrated.

3. Check all Electrode wire connections.

CARE & CLEANING

Cleaning the Heater

Follow the Trouble Shooting Guide for CLEANING THE ORIFICE. This should be done at least once

a year, more if a problem occurs.

Open the Heater Access Plate, located opposite of the Controls and clean any debris from inside the

neck. Make sure to pay special attention to the valve and ignitor.

The Emitter Screen can be cleaned with products like Oven Cleaners.

Cleaning the exterior surfaces and hood

You can wash your heater just like a car. Use mild detergent and rinse with water.

Keeping your heater clean allows it to operate and provide years of service.

If a scratch occurs in a powder coated surface, quickly touch-up with an exterior acrylic based paint.

Touching up will lessen the possiblility of rusting in that area.

Dayva International, unfortunately does not supply touch-up paint.

About 1/8" spark gap between

Electrode and Thermocouple