GAI-Tronics DEX-103 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla System interkomu GAI-Tronics DEX-103. GAI-Tronics DEX-103 15 stron. Hazardous area driller’s intercom stations

Drukuj stronę

Pub.: 42004-692L2C

DEX-103

DEX-203 D

Page 5 of 13

ODEL

AND

RILLER

NTERCOM

TATIONS

Mounting

The station consists of two enclosures that

are connected by a union. The mounting

location must be a flat, vertical surface that

provides proper clearance, rigidity and

strength to support the station.

The suggested mounting height for stations is

54 inches (137 cm) up to the center of the

factory-sealed enclosure.

To maintain the explosion-proof integrity of

these stations, they are designed with all

mounting hardware located outside the

enclosures. Refer to Figure 3 for mounting

hole and slot dimensions.

Securely fasten the factory-sealed and

termination enclosures to the mounting

location using steel mounting bolts and

washers, or washer-head bolts (hardware not

included).

Conduit Installation

Install the conduit using an approved

electrical conducting-type lubricant on the

threads. The termination enclosure on the

station has one conduit entry on each side

Figure 3. Rear view showing mounting slots

and two on the bottom of the enclosure.

All ATEX approved models contain M25 metric conduit entries. The bottom entries are plugged from the

factory and can be removed to allow use of the entry. Refer to Figure 2 for locations. All unused conduit

openings must be plugged using a close-up plug approved for the specific hazardous location where the

enclosure is used. All conduit connections must meet minimum thread engagements as specified by the

applicable electrical codes.

f:\standard ioms - current release\42004 instr. manuals\42004-692l2c.doc

11/10