Daza 4540 Podręcznik użytkownika - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Daza 4540. Daza 4540 2 stron. Wireless optiseatset plug & play
Drukuj stronę4540
Wireless Optiseatset Plug & Play
2014-05-23 - V1.0
Opening the unit
To open the unit you must remove four screws. The two lower screws are located in the battery compartment.
Alarm delay S1 and S2:
The Optiseat has an alarm delay. This is the time that the person has to sit again before the alarm will sound. Four time settings are available. These
times can be changed upon request.
The standard delay times you can choose from are: 1, 4, 10 and 255 seconds (other lengths of time are optional). The selection from among these 4
lengths of time is made using the first 2 switches S1 and S2 (figure 3).
Buzzer switch S3 and S4:
With the third switch (S3) the buzzer can be set. If this is up (ON), the buzzer is audible until the end of the alarm delay time (set with S1 and S2). If
S3 is down (OFF), the buzzer will only sound for one second, regardless of the alarm delay time.
With the fourth switch (S4), the buzzer can be switched on or off. When it is switched on, the buzzer is audible as set by S3. When it is switched off,
the buzzer is completely switched off during alarm (Figure 4).
When closing the unit, make sure the LED is positioned in the corresponding opening.
Attention!!! After changing the settings the Optiseat have to be switched off and on again to activate
the new settings!
Daza Opticare BV follows a policy of continuous improvement in the development of its products. The technical data can therefore be changed without notice.
This product is classified as an electrical and electronic device. When you decide to discard this product, please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment
(WEEE) and compliant with local laws relating to this directive.
User Manual
Figure 3: Alarm delay time
Figure 4: Buzzer On / Off
P a g e
2
o f
2