AirCycler g2-k Podręcznik szkoleniowy - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik szkoleniowy dla Termostat AirCycler g2-k. AirCycler g2-k 20 stron.
Również dla AirCycler g2-k: Instrukcja instalacji i obsługi (11 strony), Podręcznik testowania instalacji (2 strony), Podręcznik testowania instalacji (2 strony)

SAFETY CONSIDERATIONS

Read and follow manufacturer's instructions carefully. Follow all local electrical codes during installation. All wiring

must conform to local and national electrical codes. Improper wiring or installation may result in personal injury or

product and property damage.

The AirCycler® g2 requires 24VAC (R and C terminals) to be connected for proper operation. The controller will not

operate without these two connections.

The wires (R, C, & W ) from the air handler to the thermostat can run parallel with the wiring from the AirCycler®

g2 to the air handler. The fan wire (G) must be interrupted by the AirCycler® g2. Some thermostats do not require a

common (C) connection. The AirCycler® g2 requires this for power, which must be wired to the furnace.

AIRCYCLER® g2 CONTROLLER LOCATION

The AirCycler® g2 controller can be installed near the thermostat or out of view on/near the air handler unit. See the

wiring diagram on page 4.

Warning: Before installing the AirCycler®, turn off all power to the furnace. There may be more than one power to disconnect.

Electrical shock can cause injury or death.

DAMPER LOCATION

The fresh air damper can be located anywhere in the inlet duct. Minimize the length of the inlet duct to improve air

flow and improve system efficiency. It is recommended that the damper be as close to the return air plenum and the

AirCycler® g2 controller as possible, and the inlet duct connect to the return plenum upstream of the system filter, and

down- stream of any duct mounted sensors.

DAMPER INSTALLATION

The damper may be installed in any position. It is recommended to install it with the motor at the12 o'clock position if

mounted horizontally. Air may flow through in either direction, although it is recommended to install with the crimped

end as the outlet. Use care to avoid distorting the damper housing and provide adequate support. Upon system start up

be sure to set damper power switch to UP or AUTOMATIC position.

ASHRAE recommends that the fresh air intake be located at least 10 ft. from any source of pollutants, such as auto

exhaust, dryer exhaust, exhaust from any fuel-burning appliances, etc. Avoid installation near odor sources such as

garbage bins or barbecue grills. A minimum of 3 ft. above ground is recommended to avoiding ingress of leaf litter,

grass clippings, etc. Do not use a crawl space, basement, or attic as a source of intake air. Always be sure to comply with

local building codes and requirements regarding fresh air inlets.

The AirCycler® g2 is equipped with a real time battery backed-up clock for use with the Operation Hours setting ONLY.

If not setting the hours of operation, the included battery is not required. All other settings are saved in nonvolatile

memory.

AC DOC 8.5

REV 7/2020