Automatic Technology Australia Elite Instrukcje instalacji i instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcje instalacji i instrukcja obsługi dla Otwieracz do bram Automatic Technology Australia Elite. Automatic Technology Australia Elite 20 stron. Swing gate opener with remote control
Drukuj stronęI N S TA L L AT I O N O F M E C H A N I C A L D R I V E U N I T
I N S TA L L AT I O N O F M I N I M U M S I D E R O O M K I T
If you have limited Side Room, a special kit allows you to modify the Elite Swing Gate Opener so that the space required is reduced
to the width of the Drive Unit (135mm). (ATA Order code 90182).
FITTING MINIMUM SIDE ROOM KIT
STEP 3A
1. Secure the Extension Arm from the minimum side room kit
onto Drive Arm Extension with supplied M12 screws. Drill
Ø12 hole in Drive Arm Extension (use hole in extension arm
as a guide). Insert other M12 screw and secure with spring
washer and nut. Check that screws are tight (Fig 8).
2. Check the Drive Unit is DISENGAGED AND THE GATE
IS CLOSED (Fig 4). Slide the Guide Track over idler. Locate
Track on gate and check travel of the Arm. The idler should
always be inside the Guide Track in the closed and open posi-
tions. Secure (weld) track to gate (Fig 7 & 8).
NOTE
: If a shorter Arm is required, drill the Drive Arm Exten-
sion and Extension Arm where appropriate, you should not have
to cut the arms and should still be able to use pre-threaded hole in
Drive Arm Extension.
(ATA Order code 90182)
KEEP HANDS AND ANY LOOSE CLOTHING WELL
CLEAR OF THE GATE(S) AND GATE OPERATOR AT
ALL TIMES. SERIOUS PERSONAL INJURY AND/OR
PROPERTY DAMAGE CAN RESULT FROM FAILURE
FIG. 7
Page. 7
WARNING
TO FOLLOW THIS WARNING
FIG. 5
FIG. 8