Celestron 21028 Podręcznik szybkiej konfiguracji - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Teleskop Celestron 21028. Celestron 21028 2 stron. Celestron powerseeker square 60: quick setup
Również dla Celestron 21028: Specyfikacje (2 strony), Instrukcja obsługi (8 strony)
Drukuj stronę
Quick Set-up Guide [cont]
10
Locate the finderscope. Remove the rubber
ring around the finderscope.
13
Place mounting bracket over rubber ring and
tighten set screw to secure in place.
16
Pivot finderscope to desired angle and tighten
locking bolt to secure in place.
19
Tighten set screw to secure in place. Repeat
steps 18 and 19 using other two eyepieces.
22
To observe, look through the eyepiece as
shown above.
11
Slide finderscope into bracket as shown above.
14
The finderscope mounts onto the tube by
sliding the tab on the bottom of the
finderscope into the groove on the side of the
optical tube.
17
Before attaching eyepieces to the tri-ocular
holder, remove the plastic eyepiece holder
caps.
20
For additional magnification, you can use the
included 3x barlow. Place the barlow in the
tri-ocular holder in place of any eyepiece and
tighten set screw. Put desired eyepiece in barlow.
23
To change the magnification, simply rotate the
tri-ocular holder so that a different eyepiece is
at the top.
12
Place the rubber ring over the eyepeice end of
the finderscope. Slide ring about halfway down
the finderscope tube.
15
Once you locate the groove on the optical
tube, slide the finderscope into the groove. The
finderscope should be oriented so that the
large lens faces the front of the tube.
18
Insert the chrome barrel of the 20mm eyepiece
into the eyepiece holder.
21
Remove the lens cap from the front of the
telescope.
For detailed usage
information please
consult your owner's
manual.