ADEMCO LYNX Instrukcja obsługi systemu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi systemu dla Czujniki bezpieczeństwa ADEMCO LYNX. ADEMCO LYNX 14 stron.
Również dla ADEMCO LYNX: Podręcznik użytkownika (17 strony), Skrócona instrukcja obsługi (8 strony)
Drukuj stronę
Ademco Lynx System Manual
Before arming your system, all protected doors, windows, and other protection zones must be closed or bypassed. Pressing the [STATUS] key
will announce all zones that are faulted, as well as any other abnormal system condition, making it easier for you to secure any open zones.
Ready light: The green Ready indicator on the keypad will be lit if the system is ready to be armed. If blinking, the system is not ready.
Press the Status Key
Press the [STATUS] key once to announce the general status of the system. The following phrases may be heard depending on the current
state of the system:
Disarmed, ready to arm [message] [check system]
Disarmed, [not ready to arm], [message]
Armed [away] [stay] [instant] [check system]
Note: Phrases in brackets are variable, and are announced only if appropriate in the current state of the system.
Press the [STATUS] key trice to announce specific system status. The following phrases may be heard depending on the current state of the
system:
Fire alarm [zone voice descriptors]
Alarm [zone voice descriptors]
Fire fault [zone voice descriptors]
Fault [zone voice descriptors]
Low battery [zone voice descriptor]
System low battery
AC loss
Zones bypassed
Chime
System Can Be Armed
The Ready light will be lit when all protection zones have been either closed or bypassed.
You may now arm the system as usual.
Arming in Stay Mode
To arm in stay mode:
1. Enter your security and press the [STAY] button.
2. The keypad will beep three times and display the armed Stay message. The red Armed indicator will
light and the system will announce "armed Stay-exit now."
Arming in Away Mode
To arm in Away mode:
http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]