Gainbridge GT3012 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla GPS Gainbridge GT3012. Gainbridge GT3012 12 stron. Magnetic &portable gps tracker

Drukuj stronę

9.1 Routetrack

9.1.1 By button

Press On button at the back of the device to turn on routetrack function, LED flashes 5 times

indicates routetrack function is on.

9.1.2 By SMS

SMS:

*routetrack*1-99*

Device Response: "System has entered routetrack function for *XX* hours." If you sent 99 the

device responds: "Routetrack function is set to always on."

9.1.2.1 Routetrack data Collecting Interval

SMS:

*rsampling*1-999*

seconds)

9.1.2.2 Routetrack data Uploading Interval

SMS:

*rupload*60-999*

seconds, minimum rate should not be less than 60)

SMS:

*routetrackoff*

Device Response: "System has ended routetrack function."

9.2 Check Function

This check function allows for Power savings over route track of 30%-60% by controlling sampling

frequency and data upload interval. The device can be set to collect location data regularly and

uploaded to server at appointed interval. Initiate the start of interval tracking with a SMS command.

SMS:

*check*0-99*

SMS:

*checkm*10-999*

SMS:

*checkoff*

Device Response: "Notice: System has ended check function."

Noted: Check function is able to work with routetrack command at the same time.

9.3 Track Off

This turns OFF the GPRS data upload function. System will exit tracking function once receiving the

track off command, no matter which tracking mode it is in.

SMS:

*trackoff*

Device Response:

10. Deep Sleep

The Deep Sleep function enables the GT3012 to be available for long working periods needed,

tracking remotely when either the timer wakes the unit or motion is detected. The GSM and GPS

are both off during deep sleep, with only the timer drawing power. Since both the radio and GPS are

off, the

(1-98 represents hours of accumulated data, 99 means always on)

(1-999 represents seconds of data collecting interval, default as 10

(60-999 represents seconds of data uploading interval, default as 60

(0-99 represents hours of data upload interval, default as *check*0*)

(10-999 represents minutes of data upload interval)

"System has ended the tracking function."

9 / 12