Gainlab Audio BISHOP Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Wzmacniacz Gainlab Audio BISHOP. Gainlab Audio BISHOP 15 stron.
Również dla Gainlab Audio BISHOP: Skrócona instrukcja obsługi (10 strony)

Drukuj stronę

Compressor switch to the right position. The threshold values of the two

break-off points can be regulated with two separate potentiometers. The

potentiometer labeled Threshold

controls the value of the ﬁrst break-

off point. The potentiometer labeled

2ND slope controls the value of the

second point. The amount of gain

reduction can be monitored on two

LED scales. GR1 shows

the gain reduction at

the ﬁrst break point.

GR2 shows the gain reduction at the second break point.

The compression ratio and knee value can be selected as

a preset with the Character switch. The positions of the

Character switch use descriptive

names: "Soft", "Medium", "Hard". By

deﬁnition, the soft position indicates a

smaller compression ratio with a

gentle knee. The medium position

indicates a much higher compression

ratio with a more angular knee. The

hard position indicates an almost

limiter-like ratio with a sudden knee. The intervention

speed of the compressor is intended to be modiﬁed by the time constant

parameter. In Auto mode, the time constants of the compressor are

THE ONBOARD FILTER SECTION

The basic functions of the ﬁlter section include the high-

pass ﬁlter. This is actually used to remove low frequency

rumble, a useful addition to any preampliﬁer. It can be

adjusted automatically depending on the dynamic

conditions of the signal. In addition, four more

stages are available from the fastest to the slowest.

Due to the nature of the compressor, the attack and

release values are set at the same time when

selecting a time constant. In addition, the sound of

the compressor can be ﬁne-tuned by adjusting the

threshold values of the two slopes, along very wide

possibilities.