Gainsborough Traditional Series Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przez blokady Gainsborough Traditional Series. Gainsborough Traditional Series 2 stron. Installation template for gainsborough trilock
Drukuj stronę10mm
(3/8") hole
TRILOCK DUMMY
FITTING INSTRUCTIONS
– Fold template where indicated.
– Position template on door edge at
desired height.(Generally to line up
with operating Trilock on opposite door)
– Firmly hold template to door and mark
the four hole centres as indicated.
– Drill holes (suggest pilot holes first
3mm, 1/8") then the correct size
10mm, 3/8" from both sides of the
door.
Contemporary Series
– Install threaded posts to the outside
faceplate.
Traditional Series
– Install blind screws and brass posts to
Trilock external faceplate (this is the
faceplate without the rectangle snib
push-button).
– Insert dummy plug into the inside of
both plates before affixing faceplates to
door. (To help hold dummy plugs in
position, apply a strip of adhesive tape
if required.)
– Mount the outside faceplate to door.
– Align the inside faceplate to door and
fit mounting screws and tighten into
threaded posts.
10mm
(3/8") hole
Fit here on door edge
PAIT 070
JUL '11