airdeer A1 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Meble zewnętrzne airdeer A1. airdeer A1 8 stron. Automatic trash can
Również dla airdeer A1: Instrukcja obsługi (9 strony)
Drukuj stronęthe touch key within 5 seconds, the trash can will automatically lift the big lid for overfull packing; if the
key has not been pressed at the end of the "di--" prompt, the trash can will exit the packing program,
then please open the flip lid to check. If you can compress the garbage by hand, please press the
garbage below the light bar, and make sure it will not rebound, then long press the touch key again to
pack.
4.4 In actual use, if you know that the garbage is overfilled and the height exceeds the LED light bar,
you can directly lift the big lid by hand without using the automatic detection function of the trash can,
and then long press the touch key for overfull packaging.
4.5 When the voice prompts " Packing complete, please take it out", take out the packed garbage
bag。
4.6 After that, the big lid will automatically close, and the bag loading will start automatically until the
voice prompts "Bag loading complete"。
4.7 If the voice prompt "Failed bag loading, please check if the garbage bag is used up or broken",
then follow the operation in section 1.5 of this manual.
5. Charging
When the trash can voice prompts "Low battery, please charge", please use the attached charging
cable to connect a power adapter with a voltage of 5V and a rated current of 1A or more to charge.
The charging status lights up red, and lights up green when full.
6. Install a new refill ring
If the garbage bag is used up, a new refill ring needs to be installed. There are two installation
methods.
6.1 Method 1: Do not turn off the power, install a new refill ring according to the figure ①, ②, ③, ④,
⑤ in section 1.3, then long press the touch key until the fan rotation sound, and there will be a voice
prompt after the bag loading is completed. If bag loading is unsuccessful, you can follow section 1.5 to
deal with.
6.2 Method 2: Turn off the power switch first, then click the touch key to quickly discharge the circuit
board. Then follow the sections 1.3, 1.4 and 1.5 of this manual.
7. Restart the trash can
7.1 When the trash can work abnormally, you need to restart the trash can.
7.2 To restart the trash can, first turn off the power switch, and then click the touch key to quickly
discharge the circuit board; then turn on the power switch, there will be a sound of the fan rotating,
and then a voice prompt "Welcome to Airdeer automatic trash can", then the trash can restart is
completed.
7.3 If after turning on the power switch again, there is no fan rotation and no voice prompt, usually
after the power switch is turned off, the circuit board has not been fully discharged and the power is
turned on again, the trash can has not restarted.
8. Cleaning and maintenance
Please use a soft cloth with a small amount of water or neutral detergent to clean and wipe, avoid
scratching with hard objects, avoid rinsing directly with water, and do not soak in water. For products
with decorative lines, please wipe back and forth in the direction parallel to the decorative lines.
5