airdeer A1 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Meble zewnętrzne airdeer A1. airdeer A1 9 stron. Automatic trash can
Również dla airdeer A1: Instrukcja obsługi (8 strony)

Drukuj stronę
garbage bag to the bottom of the can and continue to use it. After using several times,
the inside of the refill ring becomes loose, then the bags can be loaded automatically.
1.6.
If the voice prompts "Low battery, please charge", please use the attached charging cable
to connect a power adapter with a voltage of 5V and a rated current of 1A or more to
charge. When the battery is low, bag will not be automatically loaded. Please fully charged,
then turn on the power switch to complete automatic bag loading.
2. Infrared sensor flip lid
2.1.
In order to achieve a full-coverage flip lid design, this product uses a patented side infrared
sensing technology. When close to the infrared induction port within about 10cm-20cm
above, the flip lid will automatically open, and the flip lid will automatically close after a delay
of a few seconds after leaving. Due to the weak reflection ability, the sensing sensitivity of
black or dark-colored objects will be reduced.
2.2.
If the infrared sensing signal exists continuously for more than 5 seconds, the flip lid will
enter the normally open mode and will close only after pressing the touch key.
2.3.
Commonly used methods to open the flip lid: one is to take the garbage into the sensing
area, the other is to bend the knee slightly and enter the sensing area.
2.4.
Avoid touching the infrared sensor port and keep the infrared sensor port clean. When the
infrared sensor port is dirty, the sensitivity will be reduced, and the flip lid may move by
mistake.
3. Flip lid normally open mode
3.1.
When the flip lid is in normally open mode, the flip lid will not close automatically, you need
to click the touch key once to close the flip lid.
3.2.
When the flip is closed, tap the touch key once, the lid will open and enter the normally open
mode; tap the touch key again, the lid will close.
3.3.
If the infrared sensor signal exists continuously for more than 5 seconds, the flip lid will also
enter the normally open mode.
Sensing
area