Hideaway Soft Close Series Instrukcje instalacji

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Akcesoria do prania Hideaway Soft Close Series. Hideaway Soft Close Series 4 stron. 60l base mounted laundry hamper
Również dla Hideaway Soft Close Series: Instrukcje instalacji (2 strony)

Drukuj stronę

Hideaway

Installation Instructions

60L Base Mounted

Laundry Hamper

Important Installation Information:

AT ALL STAGES OF THE INSTALLATION ENSURE THE SPRING CARRIER ON THE

RUNNER IS ENGAGED!

Before you open your soft close runners, ensure the spring carriers are loaded. Failure to do so may cause damage to your runners.

Figure 1a - Demonstrates the spring

carrier in the engaged position. This is the

correct positioning.

Runner engaged - correct

FIG 1a - Runner Engaged

Step 1 - Unpack Hideaway Bin

Remove the laundry hamper base from

packaging.

Remove the door bracket cover by

removing the M4 machine screw on right

and left side.

Soft Close Range

Figure 1b - Demonstrates the spring carrier in an disengaged position. To move into

engaged position, move the white spring carrier along its runner until it clicks into location

demonstrated by arrow in Fig 1b. Alternatively, if discovered after installation is complete

then you may also try the following: push the drawer to the firmly closed position. Push the

disengaged side of the door firmly until you hear a click from the runner re-engaging. The

runner should now close fully under normal operation and be positioned as shown in Fig 1a.

Runner disengaged - incorrect

FIG 1b - Runner Disengaged

INSTALLATION INSTRUCTIONS

Remove the door mounting bracket

from the base by removing the M6 cap

screws using the hex key provided.

Leave the runners and runner support

connected with the base plate.

The base unit is now ready to be installed.

Base Unit

Use the

Template 1 provided.

Step 2 - Secure the base

(pictured below) to mark mounting

positions for

Pre-drilling instructions are shown on the

drilling template. Please follow instructions

Drilling Installation

given then move on to Step 2b.

Use the Drilling Template 1 provided

Base

Unit.