GaitKeeper GK1820T Pielęgnacja i konserwacja - Strona 3

Przeglądaj online lub pobierz pdf Pielęgnacja i konserwacja dla Bieżnia GaitKeeper GK1820T. GaitKeeper GK1820T 3 stron.

Tightening treadmill Uprights

Over time the bolts securing the treadmill uprights may loosen causing excess movement of the pedestal during use. To

resolve this tighten the four bolts securing the treadmill pedestal using 5/32 hex key. Bolts should be tightened until snug and

there is no movement of the treadmill pedestal.

Preventative Maintenance Checklist

Run Calibration and watch and listen for anything out of the ordinary: (Call 1-800-332-9255 EXT 7104 for calibration

instructions)

problem, perform amp draw test.

Inspect the belt surfaces, topside should still have texture for grip, bottom should be porous fabric, not glazed smooth or

hard.

Inspect deck surface, should be free of scratches, abrasions or blistering.

Listen for excessive bearing noise, from standing position, in the front and rear roller and motor.

Check for front roller/belt slippage and belt tension adjustment. Look for slippage on drive pulley.

Inspect/ adjust tracking of belt.

Vacuum out motor area, being careful not to damage PWM

Inspect drive belt for wear and cracking

Wipe down machine-leave it in better condition than you found it

CALL MOBILITY RESEARCH TECHNICAL SUPPORT FOR ADDITIONAL

SUPPORT: 1-800-332-9255