dB Technologies VIO L210 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Głośniki dB Technologies VIO L210. dB Technologies VIO L210 8 stron.

Thank you for choosing a dBTechnologies Product!

VIO L210 is the new dBTechnologies flagship 2-way professional active line array module. It is equipped with: one

1.4" neodymium compression driver exit (3" titanium voice coil) and two 10" neodymium woofers (2.5" voice coil).

The full-range acoustical design includes an efficient waveguide and a phase plug with phase correctors, in order to

reach the best coherence in line-array configuration. The mechanical design allows an easy, accurate and quick

installation in flown or stack use. The powerful

(RMS power), is controlled by a DSP, which can perform a detailed customization of the output sound of the speaker.

In particular, thanks to the new dual rotary encoder interface, it is possible to accurately tune the line-array

configuration coverage, using the FIR filter technology. In addition, the integrated RDNET connections are useful for

a remote in-depth line-array control and configuration.

Check the site

www.dbtechnologies.com

1) Unpacking

The box contains:

N°1 VIO L210

N°1 100-120 V FUSE

This quick start and warranty documentation

2) Easy installation

VIO L210 can be installed in different configurations.

For a quick installation, in each side of the

loudspeakers the user can find:

Central and rear handles for easy handling (A)

- Two quick-release pin connections for frontal

mounting (B), with upper integrated front arms.

In the rear side the user can find:

- One swing rear bracket (C) for line-array mounting,

with splay angles reference holes for easy setup and

two quick-release pins.

VIO L210

www.dbtechnologies.com

DIGIPRO®

G3 amplifier section, capable of handling up to 900 W

for the complete user manual!

In order to mount the line array, for each module:

- Remove the upper front pins and lift the front arms

in the final position as shown.

- Fasten the arms with the pins in the lower holes.

- Put a second VIO L210 and remove the lower

frontal pins.

- Put this second enclosure on the top of the first.

- Insert the front arms in the position shown, aligning

the related holes.

Rev 1.0 cod. 420120248Q